Ariston PH640MT NG Especificaciones descargar pdf (Pagina 8)

6 720 608 782

Installation instructions

3 Installation instructions

3.1 Tools required for installation

• Philips head screwdriver

• Flat head screwdriver

• Adjustable wrench

• Level

• Thermometer

• Standard plumbing tools

•Manometer

• Drill

• Pipe wrench

• Adjustable pliers

• Pipe fitting tools

• Hacksaw with metal blades

•Hole saw.

3.2 Introduction

Please follow these instructions. Failure to follow

instructions may result in:

B Damage or injury.

B Improper operation.

B Loss of warranty.

If you are unable to perform the tasks required to install

this heater properly, please contact a locally licensed

plumber or gas technician.

Common installation practice is to determine the

venting/intake system layout and penetration and then

work back to the heater.

3.3 Venting

3.3.1 Vent material and specifications

Establish vent clearances that comply with the vent

manufacturer's specifications. In all cases, follow local

codes. See Table 2.

The appliance should be located as close to the point

of vent termination as possible. The maximum vent

length is 26 feet (8 m) with one 90 degree elbow and

approved terminator. Subtract 2.5 feet from the total

Warning: Do not reduce the vent

(exhaust and combustion) pipe sizes

and do not common vent with any other

vented appliance or stove.

Warning: Failure to vent the exhaust

gases to the outside with sealed

stainless steel vent pipe (AL29-4C)

may result in dangerous flue gases

filling the structure in which it is

installed.

Warning: Do not mix vent pipe or

joining methods from different

manufacturers.

Warning: Proper end terminal / rain

cap must be used. Failure to do so may

result in damage to the appliance.

This damage is not covered under

the manufacturer's warranty.

Caution: The vent system must be

installed by a qualified installer in

accordance with these instructions. If

improperly installed, a hazardous

condition such as explosion or carbon

monoxide poisoning could result.

Bosch Water Heating will not be

responsible for improperly installed

appliances.

Diam. Min.

lenght

Max.

length

Material

Exhaust

Vent

3 or 4

inches

3 feet 26 feet with

1 90° elbow

and terminal

Sealed single wall

stainless steel

(AL29-4C)

Intake

Vent

3 or 4

inches

1 90°

elbow

26 feet with

1 90°elbow

and terminal

Sealed PVC or

any other rigid

pipe

Table 2 Venting Specifications

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Comentarios a estos manuales

Sin comentarios

Ariston PH640MT NG Especificaciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Ariston PH640MT NG